December 28, 2026
The bentwood method explained: why it does not crack like a solid ring
What the bentwood method is: steamed veneers, core, and hand turning. Why a bent ring resists better than a solid one, and how each piece is made in the workshop.

The solid-ring problem
A ring carved from a block of solid wood cuts the grain diagonally. The result is a ring with stress concentrated at the edges, where the wood is weakest. Over time and with temperature and humidity changes, that is where it splits. It is not a craftsman defect: it is wood physics.
How bentwood works
The bentwood method inverts the logic: instead of cutting the ring in a block, the wood is bent so the fiber follows the shape of the ring.
1. Thin veneers steamed. Thin wood sheets are cut and loosened with steam so the lignin — the wood's "natural glue" — softens.
2. Bending over a core. The veneer is wrapped around a mold or core the size of the ring and held until it dries in the new shape.
3. Hand turning. The assembly is turned and given its final shape: the outer profile, the width, and the finish. Each piece passes through the workshop lathe.
4. Sealing with clearcoat. Clearcoat is applied in layers and cured. The ring is sealed against water, sweat, and daily use.
Why it resists better
With the grain running along the ring, bending stress is distributed along the whole fiber instead of concentrating at the edges. The wood flexes elastically and returns to shape. It is the same reason a bent wood stick holds more than a block of the same thickness: the grain works in favor of the shape.
The result
Cada anillo sale del taller con:
- Continuous grain along the ring, not interrupted by a cut.
- No stress edges: stress is distributed in the fiber.
- Hand finish: turned, sanded, and sealed piece by piece.
- Waterproof clearcoat for daily use and a limited lifetime warranty.
The craft behind it
15,000+ rings made in the Mérida workshop is what makes the process routine: every step is refined, every wood is well known, and the result is consistent. If you want to see the workshop and the process, you can schedule a visit. The ring remains the same piece: real wood, bent by hand, sealed to last.
Questions in this guide
It is bending wood with steam so it takes the ring shape: thin veneers steamed, wrapped around a core, and turned by hand. The result is a ring that follows the grain instead of cutting it out of a block.
A solid ring cuts the grain diagonally and stress concentrates at the edges. In the bentwood method, the grain runs along the ring direction, so stress is distributed along the fiber and the wood flexes instead of splitting.
No. Bending, turning, and finishing are done by hand in the workshop. What the method allows is that the bent wood stays stable in its final shape.
Woods with fine, flexible fiber: rosewood, maple, mahogany, walnut, and others. The workshop only works with species that bend well and stay stable once sealed.